Instead of explaining why I chose the outfit or anything else, I'm just gonna go straight to the business: Using box cutter, I cut desired pieces from finnfoam. Above you can see shoulder pieces cut. After I had cut everything I glued as many pieces together as needed to make the piece thick enough. I had four layers in hand armor (one layer was 3 cm), two in shoulder pieces and 1 in ears/antennas.
Then I simply sculpted the pieces. This step took several hours to make and I made several mistakes while sculpting. Luckily you can easily hide all the mistakes with clay, craft foam or cardboard
 |
| sculpting hand armor |
 |
| ear progress |
 |
| shoulder piece |
My little clay mix. I used some old clay I had had laying around for ages and for that reason it had lost a lot moisture. I fixed that by mixing it with water and it worked just fine. Though I think wood filler would have been better for filling holes and making the surface smoother.
Craftfoam I used add thickness since I had accidentally cut too much. For the corners I added cardboard to make them nice and clean. After that was done I covered all the pieces with tape.
When the bases were made I used them as mold for the worbla. Except for the ears which I only covered with worbla. Worbla was a lot easier to use than I had expected. It is quite forgiving material to work with.
 |
| Heat gun and sculpting thingies~ |
Here's all the pieces I have made so far:
 |
| ears! I just need to prime, paint and attach them to the headband and they are done! |
 |
| These little things are for the puta, his tiny cloven hoofs |
 |
| Hand armor. these still need a lot of work |
